Once again the meter can determine if moisture is present in a solid laminate even if all looks well to the naked eye.
Using a moisture meter on solid fiberglass laminate.
However it should be.
A surveyor can identify high moisture in the core or laminate using a moisture meter.
The mass production of fiberglass.
The moisture meter is an essential device to perform a good survey on a fiberglass boat.
As you ll notice a 30 moisture saturation in wood or a cored section is only equal to 3 total absorbed moisture on a solid fiberglass with no core.
This is a very important part of any moisture meter and if you don t have that scale it does not matter whether the meter tells you it is 100 or 10 because you don t know what those numbers translate to in fiberglass.
Virtually every high performance racing sail or powerboat is cored.
While a moisture meter newbie might gain some useful information more on that in a minute using one to accurately assess the state of a hull requires deep experience.
We tend to believe that solid fiberglass is stronger and less likely to suffer damage from water saturation and the latter is true.
However it is not perfect and there are drawbacks.
176 hydrolysis 177 water.
Where osmosis repair is concerned the moisture meter will enable a fiberglass specialist to determine how.
After using a moisture meter on over 1 000 surveys i have yet to see a recently hauled boat that indicated anything less than high 7 on a scale of 1 10 on surfaces below the waterline.
176 are meters affected by humidity.
Using moisture meters 173 what does a meter really detect.
176 do meters read fluids other than water.
Core rot degradation and the physical failure of the core can begin at about a 20 reading on the ct 33 sometimes sooner which is in the high moist range.
Fiberglass is a good material to use in boats as it has many good attributes.
So better to hire an experienced professional surveyor or perhaps a boat yard technician see last article to do the work for us.
176 does old gel coat absorb high amounts of water.
Lower levels of moisture are common and tapping of the area can identify if there is a problem that needs to be repaired.
Part of the problem in answering this question comes from the fact that we cannot determine whether we are reading moisture behind the laminate versus within the laminate.
